Electric central heating, wall-mounted heater, 2000 W, stainless steel heating element, dimensions 60 x 45 x 12 cm

REPLACEMENT REMOTE CONTROLThis garage door remote control is a replacement part and not an original part. Please check the compatibility list before purchasing.
COMPATIBILITY Only compatible with: ECHO TX4 433 RC, ECHO TX2 433 RC, TE443H BRAVO
FREQUENCY Ensure your original remote control operates at a frequency of 433.92 MHz for optimal compatibility.
4 CHANNELS The remote control has 4 channels for opening gates and garage doors with a single command.
BATTERIES INCLUDED The remote control comes with lithium batteries and is ready to use right out of the box.
CUSTOMER SERVICE Our knowledgeable customer service team is happy to assist you with any questions or problems.
IMPORTANT NOTE: Please do not purchase the remote control if your model is not listed. Access to the receiver is required. Please ensure you have access to your receiver/door opener before purchasing.

Description

* Frequency: 433 MHz

* Code: Rolling Code

* Channels: 4 Channels

* Material: ABS

* Battery: Battery included

* Range: 10,100 m (outdoors)

* Programming Method: Receiver Programming

Compatible Models

BRAVO TX4

ECHO TX4 RC

BRAVO TE4433H

Attention:

Not compatible with 868 MHz.

Please ensure your remote control matches the image and your model is listed.

Access to the receiver is required.

Please ensure you have access to your Receiver/door opener.

Instructions Is the programming complete?

CODING VIA THE RECEIVER

1 - On the receiver, press the button for the channel you want to code: SW1 for CH1 and SW2 for CH2. LED 1 or LED 2 will light up continuously to indicate that the receiver is in learning mode.

2 - Within 10 seconds, press and hold the button on the remote control for at least 1 second.

3 - If programming was successful, the LED will blink twice.

4 - After the first remote control has been coded, the receiver remains in learning mode; the LED will light up continuously.

5 - To code additional remote controls (up to a maximum of 256), repeat the steps from point 2.

6 - After 10 seconds have elapsed since the last programming of the remote control, the receiver will automatically end the learning phase. The learning process can be manually cancelled after programming the remote control by pressing one of the buttons (SW1 or SW2) on the receiver.